This #6210A looks much like our part #6210, except that this 6210A has a plug that is straight with the cord, and the #6210 has an “L” shaped 90 degree plug.  Both have a one piece cord that “disappears” down through a hole in the chair and normally plugs in underneath the chair to a short cord off the motor.  Both have a round plug that has five pins in a semi-circle.

This 6210A plugs into a short female five pin female plug coming from the motor, and the motor cord has a small plastic lever that folds over the plugs to lock them into place.  This control was almost exclusively used by Catnapper.  If you have a Catnapper chair with a two button hand control like this, then turn the chair over on its side and find the end of the hand control cord where it plugs into the motor; if the plug is straight with the cord, and there is a plastic lever locking the plugs into place, then order this #6210A.

If you have a slightly newer chair that has an “L” shaped 90 degree connector, then order the #6210.